10 Tips to Ensure Roof Reliability
A reminder to add roof maintenance to your spring cleaning checklist
10 tips to help keep your roof working
1.Make annual inspections of the roof to evaluate its general condition and detect any potential leakage problems before they develop. The best time for an inspection is the spring after severe weather conditions (and the damage they may have inflicted) have passed. In addition, the weather is ideal for repairs if they are necessary.
2.Make the initial inspections from the ground or through upstairs windows where the roof surface can be observed. Binoculars are a good tool to use for the inspection.
3. Keep gutters and roof surfaces clear of fallen leaves, pine needles, twigs and other litter so that water will drain freely.
4.Keep trees trimmed to prevent branches from scuffing the roof surface. This will also keep the roof surface drier helping to inhibit growths such as algae, mold, fungus or lichen. Keep climbing roses, vines and ivy trimmed back from the roof.
5.Never paint or coat asphalt roofing materials to change the color or give the roof a “new” look. The use of paint or coatings may void the manufacturer’s warranty. Consult the individual manufacturer, as this type of treatment may be detrimental to your investment. However roof surfaces may be cleaned if they are showing signs of staining from algae.
6. Never allow water from a downspout to pour directly onto a roof below as this will create additional wear to the shingle surface. Connect all upper story downspouts to a lower level gutter with drains installed on the lower roof.
7. When removing snow or ice from a valley or other roof areas, proper care must be taken to avoid damaging the roof. For safety, use a soft-bristled broom or long extension pole – never allow shovels to make direct contact with your shingles. Never climb onto a wet or snow-covered roof.
8. Inspect the underside of the roof deck from the attic to detect leaks. Flashings are the most vulnerable points, therefore, inspect the underside carefully at all flashing points for evidence of leakage, such as water stains. Remember that in cooler climates, water stains may be due to condensation as a result of inadequate attic ventilation.
9. Limit walking on roofs to a minimum to avoid damaging the surface. When workmen have to climb onto the roof to service or install a chimney, solar collector, television antenna or other roof element, require them to use care to protect the roofing. Avoid mounting satellite discs or other hardware to the roof surface to avoid future potential leak areas.
10. Whenever a new element is added to the roof, make certain proper flashing procedures are followed to maintain the integrity of the roofing. Be sure anchors are made of a non-corrosive material to eliminate the possibility of metal discoloration or “iron stains” on the roof.
If you have ANY safety concerns, call in a reputable roofing contractor to make the inspections and/or repairs for you.